The last time the Cream Dream was here was in 2003. Bryan's car is now back at JGY for some upgrades and maintenence.

We upgraded to a Walbro fuel pump.

The Cream Dream is on the dyno.

The wiring genius at JGY wired in an OBD1 diagnostic port for Bryan's '90 240. Now, we can monitor all of the car's settings.

JGY dyno'd the Cream Dream when it first arrived, and it made 187 HP and 169 ft/lbs. torque.
Click here or on the image below to view the dyno chart from the first pull.

JGY increased the fuel pressure with a Nismo FPR and increased the HP. Then, after wiring in the diagnostic port, we advanced the timing 1.5 degrees and made more power. Next, we installed a Walbro fuel pump and gained more power. Finally, we lowered the fuel pressure back a bit and made 214 HP and 190 ft/lbs. torque. We made more torque in other runs, but the highest horsepower was at 190 ft/lbs. 187 to 214 = a gain of 27 HP.

Click here or on the image below to view the dyno chart for the last pull.

A view under the hood.

Another view of Bryan's finished car.